Using Your Rubber Stamps in Collage

If you enjoy collage, you will find a lot of uses for your rubber stamps. And, if you haven’t tried cardmaking yet, I highly recommend it.  You may find it is the perfect way to experiment with new techniques or showcase small art, plus when you are done, you can mail it off to a friend!

For this project, I was actually experimenting with a tiny monoprint of a hand-drawn squirrel. I wasn’t planning to use it for anything in particular but I liked how it turned out. So I let it dry, and colored it with Prismacolor pencils to the point I thought I could make something out of it. After spending the time on it, I figured, why not use it for a card?

So I dug into my craft papers, and found some “woodsy” selections – papers with lots of fibers in them that produced interesting textures. I moistened and tore the red fiber paper so it would come out with a ragged edge. Then I cut the delicate white paper in a broad strip. Trying different ways layer and position them, I found a composition that I liked. But I needed something to tie it all together to form the base of the card.

Digging in my paper stash again, I found a piece of black card stock. Folded in half, it worked well as a card base, and I liked the dark background, but it needed something to give it visual interest. So I went to my stamps, and found the perfectly “woodsy” one for my project – Pine Bough with Cones, by Nature’s Blessings.

Nature's Blessings Fine Art Stamps

I chose silver pigment ink to match the bright value of the piece of delicate white paper, and stamped the image several times around the edge of the card, layering the images and changing their angle each time so the effect would be more like a close up of a pine tree, rather than a single branch, repeated. Sometimes I stamped twice before re-inking so the second image would be lighter, and appear to be farther away.

Then I attached the three pieces of paper with spray adhesive (this worked especially well with the delicate white paper, since any thing else I had would either tear the paper, or show through its fibers). As a final touch, I cut a piece of thick jute twine, tied it into a bow, and pulled the plied fibers apart and teased them a bit to soften their appearance. A little dab of E6000 adhesive tacked it down.

And here is the finished project, which started off as an experimental doodle!

Nature's Blessings Fine Art Stamps

 

Leave a Reply

Your email address will not be published. Required fields are marked *